Curtis Controller. Specifications: * Fits E-Z-GO 2001-UP PDS* 400 AMP* ITS Throttle* 1268 Footprint* Controller Measurements-(1268) 9"x7"x3"
Factory Replacement Controller. Fits EZGO 2000-UP PDS systems* 350 Amps* ITS throttle input
Alltrax regen non programmable solid state speed controller, includes harness. For E-Z-GO electric 2000-up PDS cars.* 300 AMP* NCX300PDS
…torque without sacrificing speed, allowing you to climb higher and haul heavier loads. System Includes: * For E-Z-GO TXT PDS 2000-2010 (36-Volt)* Motor* High Amperage Controller* High Amperage Solenoid, with diode and resistor* 4 Gauge Complete Cable Set* Hardware* Complete Instructions* *File…
Specifications:* Motor Harness* For use with 7146,D1162,3267,3268 motors* Also works with PDS Golf Carts with Stock Controllers* Fits E-Z-GO Electric 2000-Up
High torque motor. 12hp, 36-volt. For E-Z-GO PDS & DCS * MUST UPGRADE CONTROLLER , SOLENOID, AND CABLES
Curtis Controller. Fits EZGO 2001-UP PDS* 500 AMP* ITS throttle* 1268 Footprint
…23 mph on stock tires* A great package for MEDIUM DUTY lifted cars* For maximum performance, safety and durability, 4 gauge cables (1258) and heavy duty solenoid (30911 or 30912) are recommended* This controller is programmable with the Curtis hand held programmer* Controller Measurements - 9"x7"x3"
Specifications: * GE 500 amp controller* Fits E-Z-GO PDS* Up to 15mph, maximum torque* Use with motor XP2140 only
300-Amp Alltrax XCT Controller for E-Z-GO PDS 48 volt Shunt Electric Drive Systems (*cart must be upgraded to 48 volt from the stock 36 Volt) Features: * Fits E-Z-GO PDS carts with a rocker style Forward & Reverse switch and Run/Tow switch under the seat* Plug and play with your stock…
PDS controller upgrade chip for Freedom. Not for stock amp controller, red. For E-Z-GO electric 2000-up PDS
GE 500 amp controller. 48-volt only. Use with PDS stock motor and XP2125. For E-Z-GO PDS
PDS F&R rocker switch. For E-Z-Go electric 2000-up PDS (Not RXV) Replaces OEM Numbers:* 74323-G01
Specifications: * AMD high speed motor for use with Curtis 1264 and 1268 controllers* Fits E-Z-GO PDS Plus 2000-Up* A controller change is not required for speed increase of 4+ MPH with good torque *Note: Part # (3228) connector is required to install this motor
Specifications: * This shunt wound motor is a stock replacement for DV1-4001, 73291-G04* Fits E-Z-GO PDS Plus 2000-Up* Requires part #3228 connector to install
MAGNET,SPEED SENSOR,EZ PDS